Thank you so much for your involvement with the Owner's Club Forum! We hope you've gotten some great information and had the chance to interact with other owners on the current system.

We are going through a website transition, and some things might look a little different in the next few weeks. We are working on building out the system design to reflect the changes being made on our website. Please bare with us during the transition!

Need Advice Repairing Toons

LemonBayBoaterLemonBayBoater Member Posts: 4
New here, need expert advice . . . .

We have a '97 Sweetwater that we use in Lemon Bay, FL, and canals, so, saltwater.  We Snowbird, and when we put it in a couple weeks ago, a toon filled with water, and sank.  In the several years we've owned it, it's never done that, and we leave it in the water for 3-5 months. 

We have managed to get it back on the trailer, drilled small drain holes at the rear/lower area of the tubes, and a whole lot of water came out.  Probably ancient water from prehistoric time.
 B) 

I am ready to block it up off the trailer, and go to work.

Anyone know if there's more than one compartment in the toons?  The one that sank, sank in the back, where the little hole is, but the front of the toon stayed up.

1.  Any suggestions for drain plugs I can install . . . prefer non-welded.  Do I need just ones in the back, or front, too?
2.  Same for locating and patching holes.  JB Marine Weld, Aluminum putty, or . . . . ?
3.  Waterproof/sealant I can put on after the repairs are done.

Thanks.

Comments

  • LemonBayBoaterLemonBayBoater Member Posts: 4
    edited January 14
    By the way, I have seen videos on the Internet of sealing/waterproofing toons with bedliner, both spraying it on the entire toon and rolling it on the bottom half that is normally antifouling paint.

    Bedliner sounds like a good idea, so I figure it must not be.  I can't think of any reason it would deteriorate in saltwater; it's not like it is "less noble" than aluminum. 
      
    But . . . 

    I would also prefer plastic drain plugs, too, because they would not be "less noble."
  • LemonBayBoaterLemonBayBoater Member Posts: 4
    3.  Waterproof/sealant I can put on after the repairs are done.
    How about Flex Seal (As Seen On TV)?
  • LemonBayBoaterLemonBayBoater Member Posts: 4
    Funny, now that I've started blocking up the pontoon, I notice that there are three drain plugs ON TOP of each of the toons, one in the front, pointy section, one in the middle, and one at the back.

    I had not noticed them because I had looked at the back bottom.

    Why in the ---- would drain plugs be at the TOP of the toons???!!!  It would be awfully hard to tip the the boat over to empty them!!!
  • SkimanSkiman USAMember Posts: 8
    The ports on top of the pontoons are where you put air in the pontoons to check for leaks. They typically have plastic plugs screwed into them. 
Sign In or Register to comment.