Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

In this Discussion

  • Best Of...
  • Thank you so much for your involvement with the Owner's Club Forum! We hope you've gotten some great information and had the chance to interact with other owners on the current system.

    We are excited to announce that a full Forum system upgrade is under way, which will make it even easier to get answers to your questions, help other owners by using your boating experience, and receive dependable advice from our network of experts. While things may look and operate a little differently, we believe the new system will ultimately improve your Forum Member experience.

    We are doing everything we can to transition your account smoothly without you having to change your current login, username or password. You should be able to get into your account exactly the same way once the transition takes place. However, if you have any questions or comments, please leave a comment in the General Discussions category.

    We look forward to sharing new features with you as we upgrade and improve your Owner's Club Forum experience!

    Intermittent Nav light issue

    kbmoskkbmosk Member Posts: 1
    For no known reason the Nav light breaker trips.. sometimes it takes reset and sometimes can't be done. Happens very infrequently, but troublesome. Cannot reproduce to start elimination testing. Is there anything else besides nav and mast lights connected to that breaker? I replaced the breaker but of course that wasn't the problem. I would appreciate any guidance or suggestions
    Tagged:

    Answers

    • jetfixerjetfixer USAMember Posts: 45 ✭✭
      You didn't say whether or not you have LED lights or incandescent. If LED, check for loose wiring at the fixtures. The stern light, even if it's an LED bulb, will still have the same base as an incandescent. Check for loose bulb, wiring, or moisture in the socket. If they're all incandescent, check to see if the bottoms of the bulbs have rounded solder contacts, or if they look like they are flattened. If they're flattened, replace them. Due to vibration, the bulbs will, over time, get loose in the sockets and will cause slight electrical arcing. This arcing will burn away a small amount of the solder that makes contact with the base. When even a small amount of solder is lost, so is good contact with the socket points. This causes even more arcing. Strong arcing will cause the bulb to pull excess current, tripping the circuit breaker. Sometimes the bulb will make contact and function, sometimes the arcing will trip the breaker. That can be why it happens intermittently. As for loose wire connections, both positive and ground, the same thing occurs; high current draw when you switch them on can trip the circuit breaker.
    Sign In or Register to comment.